Seamless floors and true plaster walls,
in West Palm Beach.
Applied by hand over your existing tile, terrazzo or plaster. No demolition, no dumpster, and nothing torn out of a house that was built to last.
A finish, not a renovation.
Microcement is a multi-layer system applied by hand, a few millimeters thick, bonded directly to what is already there. Tile, concrete, drywall. It cures into one continuous waterproof surface with no grout lines anywhere in it.
West Palm Beach is really two markets. Part of it is towers on Flagler with the same building rules as any high-rise. Part of it is houses from the twenties in El Cid and Flamingo Park that were plastered by hand when they were built. Both are better served by adding a finish than by removing one.
The finish goes on floors, shower walls, curbless pans, feature walls, stairs, ceilings and countertops. Same system, same sealer, same hand.
In a historic district, demolition is the expensive answer.
The oldest housing stock in the county is here, and it is the stock that punishes a heavy hand. What these houses want is a finish, which is what they had to begin with.
The house was plastered by hand originally.
Venetian plaster is not a new idea on this street. It is close to what these walls were built with, so putting it back reads as restoration rather than a trend.
Terrazzo does not have to come out.
Original terrazzo is worth keeping where it is sound. Where it has been patched, stained or half covered by a later remodel, microcement goes over it without the fight of removal.
Nothing structural gets touched.
Review gets involved quickly once work goes past the surface. A finish a few millimeters thick, applied to the inside of the house, does not go past the surface.
No container on a narrow street.
Old Northwood, El Cid and Flamingo Park are not streets anyone wants a dumpster parked on for two weeks, and the neighbors will have opinions about it.
If your house sits inside a historic district we will tell you plainly what needs review and what does not, before quoting rather than after.
Drag to watch the tile disappear.
No demolition, no new plumbing, no tile torn out. Microcement applied directly over the existing surface.
Drag the handle, or use the left and right arrow keys.
Want the number for your room?
The calculator asks for square footage and which surfaces you are doing, then emails you a real range in about a minute. You get it in writing without talking to anyone first.
Every photograph below is a Monarch installation.
No stock imagery, no renders, no borrowed portfolio. These are South Florida homes Michael finished himself.
West Palm Beach north to Jupiter.
Michael is based in Deerfield Beach and runs every project personally, which sets the honest northern edge of the service area. West Palm is a normal working day. Past Jupiter it becomes a conversation.
Not on the list? Ask. If it is between Miami and Palm Beach the answer is almost always yes.
We also work in Palm Beach, Palm Beach Gardens, Wellington, Delray Beach and Stuart and Jupiter.
The man who teaches this system
leads your project.
Monarch was founded by Michael Daniels, a U.S. Marine Corps veteran and one of the first certified ForCrete installers in the country. He trains new applicators for ForCrete Americas, and he leads every Monarch project personally alongside a crew he trained himself.
He lives in Deerfield Beach and works from Miami up through Palm Beach. When you call about your West Palm Beach project, you talk to him.
Book a free consultationWhat it costs.
Pricing runs on square footage and on which system the surface needs, and the surface decides that, not us. A shower that gets wet every day is a different build from a feature wall.
There is a calculator on the home page that gives you a real range in about a minute, and it emails you the breakdown so you have it in writing. It is a range, honestly labeled as one. The firm number comes after somebody stands in the room.
Preparation, primer, mesh, base coats, color coats, sealer and labor are all in the figure.
The deposit reserves your dates. The balance is due once the finish coats are complete, before the final sealer goes on.
Your written estimate carries the actual number of days on site for your specific scope.
Before you book.
What does microcement cost?
Every project is custom, so pricing depends on surface area, existing conditions and the finish you select. Bathroom projects begin around $6,000, and most full bathrooms land between $6,000 and $18,000 depending on total surface area. Larger floor, wall and ceiling installations typically run $18 to $24 per square foot of total surface area. You get exact numbers after a short consultation.
Can it go over my existing tile?
In most cases, yes. Microcement is applied over existing surfaces like tile, concrete and drywall, which usually means no demolition and no mess. The surface does need to be sound and stable, so we confirm the condition at the site visit before anything is scheduled.
Is it really waterproof?
Yes. The system we install is fully waterproof once the primer and layers are in place, which is what makes it suitable for showers, bathrooms and other wet areas. Bathrooms are one of our most common projects.
Will it crack?
The system we install is an epoxy-based microcement, so unlike air-cured products there is no shrinkage as it cures, and it has very high tensile and compression strength. It will not fix a substrate that is unstable or damp underneath, which is exactly what gets checked before a number is written down.
How many days will you be in my house?
A single bathroom is typically 6 to 8 days on site. A multi-room project, or all the floors in a home, usually runs 8 to 12 days. A whole home is 2 to 4 weeks. Because the finish goes over the existing surface there is no demolition phase, so the schedule is short and predictable.
Do you actually work in West Palm Beach?
Yes. Michael is based in Deerfield Beach and runs every project personally from Miami up through Palm Beach, West Palm Beach included. If your street is not on the list above, ask. The answer is almost always yes.
Still deciding?
Answer a few questions about your room, then pick a time. Thirty minutes on the phone with Michael, who gives you real numbers rather than a guess. If it looks like a fit, he comes out and measures in person before anything is booked.
Salt air, humidity, and a slab that moves.
South Florida is unkind to finishes. Humidity changes how material cures, coastal buildings carry salt in the air, and what is under your tile is not always what the plans said it was.
The system we install is epoxy-based, so it does not shrink as it cures. Air-cured microcements do, and that is where hairline cracking usually comes from. It will not fix a substrate that is unstable, cracked or damp underneath, which is exactly what gets checked before a number is written down rather than discovered halfway through.
Michael is a certified ForCrete installer, one of the first in the United States, and trains new applicators for ForCrete Americas. The material is not sold to anyone without that certification. On your job he is the one holding the trowel.
OwnedForCrete
Certified Miami to
Palm BeachOwner on
Every Job
Start with a few questions.
Tell us about your room and pick a time. Thirty minutes on the phone with Michael, who will ask about the space and give you a realistic range on the call. Nothing is booked until he has seen the surface in person, and that visit costs nothing either.
Tell us about your space Get a ballpark firstOr call and text (561) 288-2474
(561) 288-2474 · [email protected] · Terms · Privacy